Veteran Garage Door Repair | Keller TX | 817-769-8488

Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has actually been giving you problems, so you require to repair it. You can fix it by replacing a circuit board, a photo-eye sensor, the main drive equipment, or the set-limit switches. You can additionally inspect if the safety and security sensing units are functioning effectively.

Replacing a circuit board

Replacing a motherboard for your garage door opener requires a few actions and tools. Initially, you require to shut off the circuit breaker and also disconnect any type of cables. Next off, open up the motherboard cover. This will certainly aid you to detect the problem as well as determine if you need a brand-new board. Next off, remove the old board as well as its wire adapters.

You can after that proceed to change the motherboard. The replacement procedure is easy as well as takes around 10 minutes. A brand-new motherboard will cost about $80. To safeguard your new circuit card from power rises, you can purchase a surge protector.

Replacing a photo-eye sensing unit

Changing a photo-eye sensing unit can be a fairly easy task. First, get rid of the sensor from the door and also make sure it is located correctly. If the sensing unit is angled at all, it might not be receiving the appropriate signal, which can be triggering the strobe lights. If you notice that the photo-eyes run out placement, you may need to have a specialist come and also fix the issue.

The photo-eye sensor contains two items that place outside of the door tracks and toward the floor. The picture eyes will have a little LED light and need to be strong in color. If the light is blinking, its likely the photo-eye is malfunctioning and will require to be replaced.

Replacing a major drive gear

To change a garage door opener major drive gear, begin by getting rid of the cap from the chain sheave. Next off, eliminate the two screws holding the drive equipment to the sprocket assembly. Currently, you can loosen the three stress pins. Squeeze them from both sides and then remove them. After that, separate the 3 cables from the garage door opener motor. These cables must be white, red, and blue.

As soon as you have actually gotten rid of the old equipment, set up a new one. Make sure to oil it well. Place the brand-new gear right into the shaft, making sure to line up the mounting openings. Make certain the equipment and gear setting up are positioned properly to make certain smooth operation. Next, utilize a hammer and also a nail to drive a pin into the new gear.

Changing the set-limit switches

The very first thing you need to do if your garage door is not working correctly is to examine the set-limit buttons. You might require to adjust them to ensure that the door closes earlier or stops prior to it reaches the flooring. You can check this by considering your garage doors handbook or online.

To change the set-limit buttons, youll need a screwdriver or outlet. Change the handle clockwise or counterclockwise until the door goes up as well as quits, or reduces its distance. To look for appropriate traveling distance, measure the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488
Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *